×
Ürünler Sepete Eklendi
Diğer

2x20mhz Analog Osiloskop MOS620

%9
13.018,02 TL
11.834,56 TL
Stok Tükenmiş
Talep Oluştur

200₺ üzeri Ücretsiz Kargo

Hızlı Kargo Gönderimi

Güvenilir Alışveriş

 


 

 

MOS 620 2 KANAL 20 MHZ ANALOG OSİLOSKOP

AYNI GÜN KARGO + TAM FATURA


ElectroKeY

 

ÖZELLİKLER:  
Vertical system:  
Verticals resolution: 8bits (28point/DIV)
Accuracy: ± 3% ± 0.4mm ( × 5MAG: ± 5% ± 0.4mm)
Equivalent bandwidth: ± 3% ± 0.4mm( × 5MAG: ± 5% ± 0.4mm) -3dB, Sine Interpolate
Interpolation: Sine/Line
 
Horizontal System:  
Maximum Sample Rates: 20MS/s
Horizontal resolution: 10bit (100point/DIV)
Time base: 0.2 ? s/DIV~10s/DIV ( × 10MAG:1s/DIV~20ns/DIV)
Sweep mode: AUTO, NORM, ROLL.
Saved waveform expand rate: Maximum 100
Trigger : Trigger preset: DIV2, 5, 8
 
Acquisition:  
Dual Channel Acquisition: 10s/DIV~0.5 ? s/DIV:CHOP; 0.2ms/DIV~0.2 ? s/DIV: ALT
Acquisition Length: 1024Byte/CH
 
Display:  
View time: 0.2s~5s Adjustable
Display Memory Length: 1024Byte/CH
Reference Memory Length: 1024Byte/CH
RS232 interface transfer rate: 19200
 
Vertical Axis:  
Sensitivity: 5mV~5V/DIV,10 steps in 1-2-5 sequence
Sensitivity accuracy: ? 3% ? × 5 MAG: ? 5% ?
Vernier vertical sensitivity: To 1/2.5 or less of panel-indicated value
Frequency bandwidth: DC~20MHz( × 5MAG:DC~7MHz); AC coupling:Low limit frequency 10Hz.
(With reference to 100KHz, 8DIV. Frequency response with-3dB.)
Rise time: Approx.17.5ns ( × 5MAG:Approx.50ns)
Input impedance: Approx.1M ? /Approx.25pF
Square wave characteristics: Overshoot: ? 5%(At 10mV/DIV range); 
Other distortions and other ranges:5% added to the above value
Dc balance shift: Adjustable on panel
Linearity: ?± 0.1DIV of amplitude change when waveform of 2DIV at graticule center is moved vertically
Vertical modes: CH1 single channel; CH2 single channel;
DUAL: CH1 and CH2 are displayed simultaneously. 
ALT or CHOP selectable at any sweep rate;
ADD: CH1+CH2 algebraic addition
Chopping repetition frequency: Approx.250KHz
Input coupling: AC, GND , DC
Maximum input voltage:  300Vpeak (AC: frequency 1KHz or lower);
* When set probe switch at 1:1, the maximum effective readout is 40Vpp(14Vrms at sine wave),or set probe switch at 10:1,the maximum effective readout is 400Vpp(140Vrms at sine wave).
Common mode rejection ratio: 50:1 or better at 50KHz sinusoidal wave.
(When sensitivities of CH1 and CH2 are set equally)
Isolation between channels: (At 5mV/DIV range): ? 1000:1 at 50KHz; ? 30:1 at 20MHz
CH1 signal output: At least 20mV/DIV into a 50 ? termination. Bandwidth is 50Hz to at least 5MHz
CH2 INV BAL: Balanced point variation: ? 1DIV(Reference at center graticule)
 
Triggering:  
Triggering source: CH1, CH2, LINE, EXT
Coupling:  AC: 20Hz to 20MHz
Slope: +/-
Sensitivity: 20Hz~2MHz: 0.5DIV, TRIG-ALT:2DIV, EXT:200mV; 2~2MHz:1.5DIV TRIG-ALT:3DIV, EXT:800mV;
TV: Sync pulse more than 1DIV (EXT:1V)
Triggering modes: AUTO; NORM: TV-V: TV-H: (Both TV-V and TV-H synchronize only when the synchronizing signal is negative)
EXT triggering signal input: Input impedance/: Approx:1M ? /approx.25pF; Max.input voltage 300V(DC+AC peak), AC: Frequency not higher than 1KHz
 
Horizontal Axis:  
Sweep time: 0.2 ? Sec~0.5Sec/DIV, 20steps in 1-2-5 sequence;
Sweep time accuracy: ± 3%
Sweep magnification: 10 times
× 10MAG sweep time accuracy: ±5 %(20nSec~50nSec are uncalibrated);
Vernier sweep time control: ? 1/2.5 of panel-indicated value
Linearity: ± 3%, × 10MAG: ±5 %(20nSec~50nSec are uncalibrated);
Position shift caused by × 10MAG: Within 2DIV. at C R T screen center
 
X-Y Mode:  
Sensitivity: Same as vertical axis. (X-axis: CH1 input signal;Y-axis:CH2 input signal.); Frequency bandwidth: DC to at least 500KHz; X-Y phase difference: ? 3 o at DC~50KHz
 
Z Axis:  
Sensitivity: 5Vp-p (Positive-going signal decreases intensity);
Frequency bandwidth: DC~2MHz
Maximum input voltage: 30V (DC+AC peak, AC frequency ? 1KHz)
Input resistance: Approx.47K ?
 
Calibration Voltage:  
Waveform: Positive-going square wave;
Frequency: Approx.1KHz
Duty ratio: Within 48:52
Output voltage: 2Vp-p ± 2%
Output impedance: Approx.1K ?
 
C R T  
Type: 6-inch rectangular type, internal graticule
Phosphor: P31
Acceleration voltage: Approx.2KV
Effective screen size: 8 × 10DIV(1DIV=10mm(0.39in)
Graticule: Internal
Trace rotation:  Provided

 

TÜRKİYE'NİN HER YERİNE ÜCRETSİZ KARGO 

 

 

HAFTA İÇİ SAAT:17:00 KADAR VERİLEN SİPARİŞLER AYNI GÜN KARGO İLE GÖNDERİLİR

 

CUMARTESİ  GÜNÜ SAAT:12:00 KADAR VERİLEN SİPARİŞLER AYNI GÜN KARGO İLE GÖNDERİLİR.

 

Dükkanımızdan Satın Alacağınız Ürünler Faturalı Olarak Gönderilmektedir.  

FATURA BİLGİLERİNİZİ MUTLAKA BİLDİRİNİZ.

 

DurumSıfırGarantiVar, BaşlamamışKutuVar, Açılmamış

Stok Kodu TEKNK-883
Barkod 6911616399503
EAN 6911616399503
KDV %20
Kategoriler Osiloskoplar
Markalar Diğer
Etiketler 2x20mhz Analog Osiloskop MOS620
Kullanım Durumu Yeni

Ürünü değerlendirmek için hesabınıza giriş yapmalısınız.
Giriş Yap

Sepet (

0

)
Sepetinizde ürün bulunmamaktadır.
Eğer bir ürün satın almak istiyorsanız almak istediğiniz ürünün sayfasına gidiniz.
Alışveriş Yap